Tag Archives: Spindle Housing
Replace Your Omni Bearings with Proper Ones
My Omni Faceting Machine shipped with NSK 6202VV bearings. These bearings are deep-groove ball bearings with double rubber seals – one on each side. However they are “non-contact” seals, meaning that the rubber does not touch the inner ring of … Continue reading
Posted in Bearing Protection, Blog, Omni Quality?
Tagged design flaws, flooded bearings, modifications, Spindle Housing, Splash Pan
Leave a comment
Protecting Your Omni Spindle Bearings
Here is a simple modification I did to my Splash Pan to help protect the Spindle Bearings and other components from water and corrosion. After disassembling the Platen and Spindle and Splash Pan I washed out all the rock dust … Continue reading
Posted in Bearing Protection
Tagged design flaws, flooded bearings, modifications, Spindle Housing, Splash Pan
1 Comment
Flooded Bearings a Fact of Omni Use
I have been contacted by several different Omni-E Faceting Machine owners. All of us have experienced water leaks and bearing problems on our machines, and those of us who have sent them back to the Jersey Instruments factory for repair … Continue reading
Posted in Flooded Bearings
Tagged design flaws, factory defects, flooded bearings, Omni Warranty, poor quality, Spindle Housing, Splash Pan
6 Comments
Removing the Omni Spindle Housing
First remove the Platen and Spindle. Removing the Splash Pan will make your job easier, though the photos here show removing the Spindle Housing with the Splash Pan still attached. The Spindle Housing is a machined block of aluminum which … Continue reading
Posted in Spindle Housing
Tagged design flaws, disassembly, flooded bearings, Omni Warranty, Spindle Housing, Splash Pan
Leave a comment