Category Archives: Transfer Jig

Photos and discussion of problems with the Omni transfer jig.

New Polymetric Transfer Jig

Posted on September 15, 2008 by allan

Updated Feb 7, 2010 – added photos of the Polymetric Transfer Jig. On a tip from a reader I ordered a transfer jig from Polymetric. I finally have given it a try and it works much better than the stock … Continue reading →

Posted in Blog, Transfer Jig | Tagged | 3 Comments

The Omni Transfer Jig is Sloppy

Posted on June 8, 2008 by allan

There have been several people writing about the Omni Transfer Jig not being accurate and introducing transfer alignment errors. I too am experiencing these problems, but I have been able to isolate the cause and reduce its effects during transfer. … Continue reading →

Posted in Omni Quality?, Transfer Jig | Tagged , | 6 Comments